Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Box fitment question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jasontb2000" data-source="post: 73573" data-attributes="member: 542188"><p>If your planning on using a shop then they should have no problems designing the enclosure. It depends on if they want to spend the time on it. Most shops will try and talk you into 2 subs with a pre-fab box. This way they decrease the time they spend on the install but still charge you for a custom install. I do not use pre-fab enclosures. The main reason is becasue they are cheap built. The dim. of the enclosure are as follows:</p><p></p><p>(These are outside dim.)</p><p></p><p>61" wide, 17.5" tall, 6" deep(@ top) and 9" deep(@Bottom). This should give you .96 Cu.Ft. for each chamber before the subs are installed. I would charge about $85 for this enclosure and would offer to build it for you but if you add shipping you would be better of finding some one closer. Also make sure they use MDF.</p></blockquote><p></p>
[QUOTE="Jasontb2000, post: 73573, member: 542188"] If your planning on using a shop then they should have no problems designing the enclosure. It depends on if they want to spend the time on it. Most shops will try and talk you into 2 subs with a pre-fab box. This way they decrease the time they spend on the install but still charge you for a custom install. I do not use pre-fab enclosures. The main reason is becasue they are cheap built. The dim. of the enclosure are as follows: (These are outside dim.) 61" wide, 17.5" tall, 6" deep(@ top) and 9" deep(@Bottom). This should give you .96 Cu.Ft. for each chamber before the subs are installed. I would charge about $85 for this enclosure and would offer to build it for you but if you add shipping you would be better of finding some one closer. Also make sure they use MDF. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Box fitment question
Top
Menu
Home
Refresh