Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
box confusion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Mr Cabinetry" data-source="post: 4060758" data-attributes="member: 571490"><p>The angles your asking about are not really what matters so much in that the dimensions you have determine what the angle are. But, without a frame of reference as to what the measurements are from a 90 degree square point, the lengths of each dimensions make determining the those angles difficult.</p><p></p><p>What you could do is use Google SketchUP to create each dimension length and then rotate each line to connect to the others based on their lengths.</p><p></p><p>Don't change the length of the lines, you'll have to keep adjusting the degree of angle till all lines connect to re-create that which you are doing from the pictures.</p><p></p><p>I know that's not the college answer you looking for, but, given the info available, that is the way I would try to do it and tweak the design in sketchup to get it close as possible.</p></blockquote><p></p>
[QUOTE="Mr Cabinetry, post: 4060758, member: 571490"] The angles your asking about are not really what matters so much in that the dimensions you have determine what the angle are. But, without a frame of reference as to what the measurements are from a 90 degree square point, the lengths of each dimensions make determining the those angles difficult. What you could do is use Google SketchUP to create each dimension length and then rotate each line to connect to the others based on their lengths. Don't change the length of the lines, you'll have to keep adjusting the degree of angle till all lines connect to re-create that which you are doing from the pictures. I know that's not the college answer you looking for, but, given the info available, that is the way I would try to do it and tweak the design in sketchup to get it close as possible. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
box confusion
Top
Menu
What's new
Forum list
