Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
BitOne problem,, HELP!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="JDBoogie" data-source="post: 6911283" data-attributes="member: 592564"><p>The line driver is so that my amps get the correct voltage. I am using the Tru line driver that was meant to be used with the Tru amps. My signal flows from HU -&gt; BitOne -&gt; line driver -&gt; amps. There shouldnt be a problem with the signal flow.</p><p></p><p>The bitone is seeing the speaker inputs as high inputs and they are set up so that the tweets are on ch's 1&amp;2 and the mids are on 3&amp;4. In the bitone setup the sw is seeing all 4 spkrs. Im still clueless.</p><p></p><p>Where is chandler? Im almost at the point that i am willing to pay someone to help me with this.</p></blockquote><p></p>
[QUOTE="JDBoogie, post: 6911283, member: 592564"] The line driver is so that my amps get the correct voltage. I am using the Tru line driver that was meant to be used with the Tru amps. My signal flows from HU -> BitOne -> line driver -> amps. There shouldnt be a problem with the signal flow. The bitone is seeing the speaker inputs as high inputs and they are set up so that the tweets are on ch's 1&2 and the mids are on 3&4. In the bitone setup the sw is seeing all 4 spkrs. Im still clueless. Where is chandler? Im almost at the point that i am willing to pay someone to help me with this. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
BitOne problem,, HELP!!
Top
Menu
What's new
Forum list
