Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Big 3 wire heat resistance
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jleecong" data-source="post: 517583" data-attributes="member: 554993"><p>Electric tape and heat are enemies. I use the crimp on battery terminals (hammer it closed) and then use the little red/black/blue cover that came with the terminal to cover the connector.</p><p></p><p>I have my Block to Ground and Battery to Ground upgraded with 4GA Knukonceptz wire and haven't had problems. The wire that runs over my exhaust manifold that connects the block to the chassis get a little warm and "soft" but looks fine. Knukonceptz wire has an even higher temp rating than weldingsupply.com.</p></blockquote><p></p>
[QUOTE="jleecong, post: 517583, member: 554993"] Electric tape and heat are enemies. I use the crimp on battery terminals (hammer it closed) and then use the little red/black/blue cover that came with the terminal to cover the connector. I have my Block to Ground and Battery to Ground upgraded with 4GA Knukonceptz wire and haven't had problems. The wire that runs over my exhaust manifold that connects the block to the chassis get a little warm and "soft" but looks fine. Knukonceptz wire has an even higher temp rating than weldingsupply.com. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Big 3 wire heat resistance
Top
Menu
What's new
Forum list
