Reply to thread

Message

<blockquote data-quote="keep_hope_alive" data-source="post: 7461460" data-attributes="member: 576029">I would start with the following:HU Front RCA Output -&nbsp; feeds 3Sixty.2 front inputsHU Rear RCA Output - not usedHU Sub RCA Output - feeds 3Sixty.2 sub inputsHU Rear Speaker Output - powers the rear coaxial drivers directly3Sixty.2 Front RCA Output - feeds Arc front inputs3Sixty.2 Rear RCA Output - feeds Arc rear inputs3Sixty.2 Sub RCA Output - feeds Arc sub inputsArc Amp Front Speaker Output - powers front Diamond tweetsArc Amp Rear Speaker Output - powers front Diamond woofersArc Amp Sub Speaker Output - powers subwooferIn the 3Sixty.2:- set front output to High pass around 4kHz- set rear output to Band pass between about 63Hz - 4kHz- set sub output to Low pass around 80HzIn the Arc Amp- bypass all crossovers (set to Full)- set to 4 ch in with direct sub inputs.In the HU- set rear speaker output to High pass around 120Hz- bypass front and rear crossovers (outputs to Full)- use fader to fade to front so that the rear speakers are given less power - giving you more usable HU volume</blockquote>

[QUOTE="keep_hope_alive, post: 7461460, member: 576029"] I would start with the following: HU Front RCA Output - feeds 3Sixty.2 front inputs HU Rear RCA Output - not used HU Sub RCA Output - feeds 3Sixty.2 sub inputs HU Rear Speaker Output - powers the rear coaxial drivers directly 3Sixty.2 Front RCA Output - feeds Arc front inputs 3Sixty.2 Rear RCA Output - feeds Arc rear inputs 3Sixty.2 Sub RCA Output - feeds Arc sub inputs Arc Amp Front Speaker Output - powers front Diamond tweets Arc Amp Rear Speaker Output - powers front Diamond woofers Arc Amp Sub Speaker Output - powers subwoofer In the 3Sixty.2: - set front output to High pass around 4kHz - set rear output to Band pass between about 63Hz - 4kHz - set sub output to Low pass around 80Hz In the Arc Amp - bypass all crossovers (set to Full) - set to 4 ch in with direct sub inputs. In the HU - set rear speaker output to High pass around 120Hz - bypass front and rear crossovers (outputs to Full) - use fader to fade to front so that the rear speakers are given less power - giving you more usable HU volume [/QUOTE]

Verification