Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Bending Plexi ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ss3079" data-source="post: 687862" data-attributes="member: 542009"><p>The one I used was simply two flat pieces of wood running parallel to eachother with a strip in the middle that produced heat. I don't know what was under it, perhaps a coil from a heater or something.</p><p></p><p>You'd put lines on opposite sides of the plexi and line them up in the middle of the heat strip (only about an inch wide). Bend it when it's not heated enough, it'll snap. Let it get too hot and it'll melt into the strip. Depends on the thickness of the plexi, of course.</p><p></p><p>Not all that complicated ... just takes some practice and a steady hand when bending.</p><p></p><p>- Steve</p></blockquote><p></p>
[QUOTE="ss3079, post: 687862, member: 542009"] The one I used was simply two flat pieces of wood running parallel to eachother with a strip in the middle that produced heat. I don't know what was under it, perhaps a coil from a heater or something. You'd put lines on opposite sides of the plexi and line them up in the middle of the heat strip (only about an inch wide). Bend it when it's not heated enough, it'll snap. Let it get too hot and it'll melt into the strip. Depends on the thickness of the plexi, of course. Not all that complicated ... just takes some practice and a steady hand when bending. - Steve [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Bending Plexi ?
Top
Menu
What's new
Forum list
