Reply to thread

Message: <blockquote data-quote="PV Audio" data-source="post: 2390927" data-attributes="member: 554493"><p>A miter joint is done by cutting the edges of the panels at 45 degree angles. That way, you have over 1/5 more surface area (think 45-45-90 triangle) to glue. There also isn't a way for the internal pressure to blow one of the joints apart easily because if you don't set the joint properly, it won't look right. It's an easy way to get more strength, I use it only exclusively in home audio subs though.</p></blockquote><p></p>

Top