Reply to thread

Message

<blockquote data-quote="stillfly45" data-source="post: 5264122" data-attributes="member: 595094">I just got it and I am messing around with it. But i dont understand how the part list tab works.I made a vented box and the prats list gives me cut-out pieces for the box and then more cut-out pieces for the vent.The way the list pieces makes it seem that the vent will be added to the outside of the box. I was wondering if there is a way to get the vent put inside the box and get actual cutouts.^^ so thats prolly very confusing. Here the box i made is 14.75in. X 23in. X 37in.Here is the parts list:Box Parts (Optimum Square Prism)1 Top, 1 Bottom:&nbsp; 37.04 © x 23 (b) in0.75 (thick) in1 Front:&nbsp; 13.29 (a) x 21.5 (d) x 1.5 (thick) in1 Back:&nbsp; 13.29 (a) x 21.5 (d) x 0.75 (thick) in2 Sides:&nbsp; 13.29 (a) x 37.04 © x 0.75 (thick) inVent Parts1 Top, 1 Bottom:&nbsp; 5in. (e) x 21.89 (h) in0.75 (thick) in2 Sides:&nbsp; 13.29 (g) x 21.89 (h) x 0.75 (thick) in^^ see why do they give me a cutout for the top and bottom of the port? Shouldnt the front of length of the box be smaller than the back to make up for port with?help plz</blockquote>

[QUOTE="stillfly45, post: 5264122, member: 595094"] I just got it and I am messing around with it. But i dont understand how the part list tab works. I made a vented box and the prats list gives me cut-out pieces for the box and then more cut-out pieces for the vent. The way the list pieces makes it seem that the vent will be added to the outside of the box. I was wondering if there is a way to get the vent put inside the box and get actual cutouts. ^^ so thats prolly very confusing. Here the box i made is 14.75in. X 23in. X 37in. Here is the parts list: Box Parts (Optimum Square Prism) 1 Top, 1 Bottom: 37.04 © x 23 (b) in 0.75 (thick) in 1 Front: 13.29 (a) x 21.5 (d) x 1.5 (thick) in 1 Back: 13.29 (a) x 21.5 (d) x 0.75 (thick) in 2 Sides: 13.29 (a) x 37.04 © x 0.75 (thick) in Vent Parts 1 Top, 1 Bottom: 5in. (e) x 21.89 (h) in 0.75 (thick) in 2 Sides: 13.29 (g) x 21.89 (h) x 0.75 (thick) in ^^ see why do they give me a cutout for the top and bottom of the port? Shouldnt the front of length of the box be smaller than the back to make up for port with? help plz [/QUOTE]

Verification