Reply to thread

Message

<blockquote data-quote="Apocalypse boy" data-source="post: 6681850" data-attributes="member: 561690">LOl ok bro. just because i&#039;m on ca.com, doesn&#039;t mean i have te knowledge base of a total noob. Everything wasjust about the same. Gain for both were set for 3k with the AP and with the PA it was set for 4k. Sub was a d1.4 BTL. Tone was 42 hz. Mic placement was at a dbdrag event&#039;s both time by the same judge (Mike Hadden) so Mic couldn&#039;t have been too off from where it was the first time. It&#039;s&nbsp; South Florida. Besides this past freakish winter the temps are never more than 10 degree&#039;s off from each other.&nbsp; So yes you have to go on.... The voltage drop is irrelevant.. I hdad more than adequate voltage for a burp. With the adiopipe i dropped to 12.1 and with the Power Acoustik&#039;s it dropped to i believe 11.7.Yes i am well aware of the Power acoustik not being able to put out anywhere near 2.3k. It was tested that with serious voltage drop the Power acoustik did a little over 1.2k I believe. Yep thats shit for what it rated for, BUT 2 of them with better voltage less impedance rise as they were in my setup, yet the Audiopipe still did over a decibel higher. Means the audiopipe DOES do more than 2k. Which the Merlin was tested to do. Which is the amp he is comparing it to in this thread for an spl build.Yes i also know the there is more than power output to db readings on the TL. BUT i guarantee the Audiopipe will do a higher number and is just as reliable. /thread</blockquote>

[QUOTE="Apocalypse boy, post: 6681850, member: 561690"] LOl ok bro. just because i'm on ca.com, doesn't mean i have te knowledge base of a total noob. Everything wasjust about the same. Gain for both were set for 3k with the AP and with the PA it was set for 4k. Sub was a d1.4 BTL. Tone was 42 hz. Mic placement was at a dbdrag event's both time by the same judge (Mike Hadden) so Mic couldn't have been too off from where it was the first time. It's South Florida. Besides this past freakish winter the temps are never more than 10 degree's off from each other. So yes you have to go on.... The voltage drop is irrelevant.. I hdad more than adequate voltage for a burp. With the adiopipe i dropped to 12.1 and with the Power Acoustik's it dropped to i believe 11.7. Yes i am well aware of the Power acoustik not being able to put out anywhere near 2.3k. It was tested that with serious voltage drop the Power acoustik did a little over 1.2k I believe. Yep thats shit for what it rated for, BUT 2 of them with better voltage less impedance rise as they were in my setup, yet the Audiopipe still did over a decibel higher. Means the audiopipe DOES do more than 2k. Which the Merlin was tested to do. Which is the amp he is comparing it to in this thread for an spl build. Yes i also know the there is more than power output to db readings on the TL. BUT i guarantee the Audiopipe will do a higher number and is just as reliable. /thread [/QUOTE]

Verification