Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
AudioControl question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="sstumpf" data-source="post: 8486837" data-attributes="member: 657080"><p>I am wanting to put a single 10" and upgraded front components in my 11 silverado. But keep the factory HU. Using a 5 channel amp.</p><p></p><p>Question is, can I get away with using the lc2i tapping into the factory rear speaker wires for my full range signal. Then using the main output on the lc2i for the front component set and use the bass output for the sub channel? Sound like it should work, just wanted to make sure.</p></blockquote><p></p>
[QUOTE="sstumpf, post: 8486837, member: 657080"] I am wanting to put a single 10" and upgraded front components in my 11 silverado. But keep the factory HU. Using a 5 channel amp. Question is, can I get away with using the lc2i tapping into the factory rear speaker wires for my full range signal. Then using the main output on the lc2i for the front component set and use the bass output for the sub channel? Sound like it should work, just wanted to make sure. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
AudioControl question
Top
Menu
What's new
Forum list
