Reply to thread

Message: <blockquote data-quote="headless" data-source="post: 2077241" data-attributes="member: 566363">I'd use a single distro block.  The wire for these preamp devices only needs to carry ~1-3amps...18gauge should be fine.  When i had this and an external crossover, i simply twisted 2 18ga wires together with the power wire that was going to my amplifier and shoved them into the same receptable on the distribution block - 2 were twisted into the positive wire and 2 into the ground - one for the epicenter +/- and one for the x-over's +/-Like so. I drew in the remote wiring from the HU as i remember you asked about that also. Red = Positive wiring, Black = Negative wiring, Blue = Remote wire.</blockquote>

Top