Reply to thread

Message: <blockquote data-quote="Pl8er" data-source="post: 4133564" data-attributes="member: 540634">Yes, go slowly, double check your work.  Be careful of static discharge (use a ground strap or wear shoes while doing it) but don't go to the point of thinking that if any static hits it, it is dead.  Just be careful.  Also, put the risers (for under the motherboard) on every hole that the motherboard can support.  Multi-layer boards can be damaged by too much pressure in certain spots.  Make sure it is being balanced like it should be but do not put them in places where the riser is just sitting on the board.That case should work just fine.  Looks to have plenty of room.</blockquote>

Top