Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Anybody use speaker box lite?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Rosshimself" data-source="post: 8745033" data-attributes="member: 682871"><p>I understand you there. This is a low power low fs woofer with a mass loaded dust cap. That’s actually the main reason I have any concerns about the function I can’t find the mmd for the driver. I know it’s meant for small sealed enclosure, that’s why I am not trying to go ported with it. I have plenty of time to play with the design so I’m trying to pin down the airspace and tuning then I’ll make it fit in the vehicle. I have plenty of room to work with for something like this instead of a little sealed box tucked in the corner. I am trying to absorb the advice from you guys. That’s why I posted the auto generated one because it is close to the response I would like. I’m probably gonna end up going a little bit larger on the ported side but seeing the wide range of output was encouraging. I don’t really need my output so low, or high, so I think increasing the size of the ported side is a good compromise to increase output a bit and narrow the pass band a little bit. I hope you are not tired of this conversation because I am enjoying your insight.</p></blockquote><p></p>
[QUOTE="Rosshimself, post: 8745033, member: 682871"] I understand you there. This is a low power low fs woofer with a mass loaded dust cap. That’s actually the main reason I have any concerns about the function I can’t find the mmd for the driver. I know it’s meant for small sealed enclosure, that’s why I am not trying to go ported with it. I have plenty of time to play with the design so I’m trying to pin down the airspace and tuning then I’ll make it fit in the vehicle. I have plenty of room to work with for something like this instead of a little sealed box tucked in the corner. I am trying to absorb the advice from you guys. That’s why I posted the auto generated one because it is close to the response I would like. I’m probably gonna end up going a little bit larger on the ported side but seeing the wide range of output was encouraging. I don’t really need my output so low, or high, so I think increasing the size of the ported side is a good compromise to increase output a bit and narrow the pass band a little bit. I hope you are not tired of this conversation because I am enjoying your insight. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Anybody use speaker box lite?
Top
Menu
Home
Refresh