Reply to thread

Message: <blockquote data-quote="Immacomputer" data-source="post: 3652901" data-attributes="member: 570419"><p>Make your own. It's not hard and can be done with some 1/8" mdf or similar type of wood. Just cut out a hole for the bit to pass through and then mount it with screws from underneath. To get the cutout radius, use a square and place the bit in the inside corner and measure out. This gives you the distance to the center from the outside of the bit. It works the same way as a jasper jig and as you make more an more circles, just label the centers for the radius you cut out. Over time, you will basically have your own jig for about $3.</p></blockquote><p></p>

Top