Reply to thread

Message: <blockquote data-quote="Papermaker85" data-source="post: 8524769" data-attributes="member: 572595">the steel used by SJA is 1008 while the steel in hte current driver is 1012 also the y30 is a tad weaker than the y35.. so the combination of the better steel for magnetization and better magnets (y35 and a good magnetizer) i should beable to get the QES closer to .45. tht and im going to try to use a different former and spider to save weight as long as it has a linear KMS curve past 25mm..Im pretty set on htis driver but ill give george a chance because its american stuff. basically its more of MY preference of the drivers design not that its necessarily better in every situation..</blockquote>

Top