Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
Amplifying tweets AND mids?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="PapaGeno21" data-source="post: 8016175" data-attributes="member: 581625"><p>That is where I am confused. SO I would need to run the tweets on one channel that way I can set their crossovers different than the mids. So I would run the mids on the other channel...</p><p></p><p>SO would I do this if it was a 4 channel amp?</p><p></p><p>Tweets on first/second channel, they would be in the front left and right doors.</p><p></p><p>6.5" Mids in the 3rd/4th channel. They would be wired in parallel or series whatever gives me the right ohm load but there would be two 6.5's per channel so channel 3 has two of them on the left side each doing a door and same for the right side on the 4th channel?</p><p></p><p>I am assuming I would just have to turn the gains down significantly for the 1/2 channel as to not blow the crap out of my tweets?</p></blockquote><p></p>
[QUOTE="PapaGeno21, post: 8016175, member: 581625"] That is where I am confused. SO I would need to run the tweets on one channel that way I can set their crossovers different than the mids. So I would run the mids on the other channel... SO would I do this if it was a 4 channel amp? Tweets on first/second channel, they would be in the front left and right doors. 6.5" Mids in the 3rd/4th channel. They would be wired in parallel or series whatever gives me the right ohm load but there would be two 6.5's per channel so channel 3 has two of them on the left side each doing a door and same for the right side on the 4th channel? I am assuming I would just have to turn the gains down significantly for the 1/2 channel as to not blow the crap out of my tweets? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
Amplifying tweets AND mids?
Top
Menu
What's new
Forum list
