Reply to thread

Message

<blockquote data-quote="csu87" data-source="post: 8289179" data-attributes="member: 608868">So I have an IA20.1 I was putting in this morning.&nbsp; Power wires hooked up, RCAs hooked up, Subs hooked up, and everything is in its correct place.&nbsp; I hook up the remote wire, turn on the car, and nothing happens.&nbsp; I also have an IA3.4 that is hooked up from the same power source and same remote turn on source and works with no issues.&nbsp; I have also verified I get 12+V at the power inputs and the remote turn on input.My troubleshooting:As im troubleshooting, I notice that when the amp gets a 12v signal on the remote turn on input, you can hear a relay click, but neither the &quot;On&quot; nor &quot;Protect&quot; Light lights up.&nbsp; Thinking it is just a light issue, I test the outputs and still nothing.&nbsp; No burnt marks on the board and no noticeable burnt electronics smell.Any suggestions on what to check for next?&nbsp;&nbsp; I am going to go back through and make sure there isn&#039;t a loose wire somewhere.&nbsp; I did pull my meter out and poke around the board a little to make sure I was getting voltage everywhere I am supposed to and it seems ok, but I could be wrong.</blockquote>

[QUOTE="csu87, post: 8289179, member: 608868"] So I have an IA20.1 I was putting in this morning. Power wires hooked up, RCAs hooked up, Subs hooked up, and everything is in its correct place. I hook up the remote wire, turn on the car, and nothing happens. I also have an IA3.4 that is hooked up from the same power source and same remote turn on source and works with no issues. I have also verified I get 12+V at the power inputs and the remote turn on input. My troubleshooting: As im troubleshooting, I notice that when the amp gets a 12v signal on the remote turn on input, you can hear a relay click, but neither the "On" nor "Protect" Light lights up. Thinking it is just a light issue, I test the outputs and still nothing. No burnt marks on the board and no noticeable burnt electronics smell. Any suggestions on what to check for next? I am going to go back through and make sure there isn't a loose wire somewhere. I did pull my meter out and poke around the board a little to make sure I was getting voltage everywhere I am supposed to and it seems ok, but I could be wrong. [/QUOTE]

Verification