Reply to thread

Message: <blockquote data-quote="yungstarter" data-source="post: 6754361" data-attributes="member: 620116">UPDATElooked at all fuses and there didnt seem to be a crack in any of them. Replaced the fuses in distribution block and checked with a meter. THough unsure if i was using meter right i did get a reading on power switch so there has to be current going through the wire. But its still not getting to amp and the amp wont turn on. By all means i know it should be turning on."Could it be too low current or low voltage? i really dont know whats wrong so all input is appreciated. No fuses look blown, even in amp, but amp not getting power and turning on.</blockquote>

Top