Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Amp to Sub Wiring Advice
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="NicV" data-source="post: 8691540" data-attributes="member: 678528"><p>I’m going to use the existing wiring between the RF Amp and RF Subwoofers but I had to cut the subs off as the wires were soldered to the terminals and there wasn’t enough spare length in the wire to be able to unsolder them.</p><p></p><p>The wiring is 12 gauge and my plan is to re-solder a short length of wire to the sub terminals and then fit a male/female plug to connect to the wiring to the amp (rather than splice them together). Question is, what type of plug/connector would be best to use? Bullet connectors or is there a better option?</p></blockquote><p></p>
[QUOTE="NicV, post: 8691540, member: 678528"] I’m going to use the existing wiring between the RF Amp and RF Subwoofers but I had to cut the subs off as the wires were soldered to the terminals and there wasn’t enough spare length in the wire to be able to unsolder them. The wiring is 12 gauge and my plan is to re-solder a short length of wire to the sub terminals and then fit a male/female plug to connect to the wiring to the amp (rather than splice them together). Question is, what type of plug/connector would be best to use? Bullet connectors or is there a better option? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Amp to Sub Wiring Advice
Top
Menu
Home
Refresh