Reply to thread

Message

<blockquote data-quote="z-ham" data-source="post: 6288948" data-attributes="member: 614324">My amp will play just fine at normal volumes, but when I turn it past 25 or more on the head unit it will play maybe for a bit depending on the bass on the song. If my bass hits hard then it will go into protect mode. I have checked everything to see if i have it wired right, and everything is a go. I&#039;ve been on multiple sites and checked everything that is usually wrong with wiring. I have trouble shot it for a while and can&quot;t seem to figure out what is wrong with my setup. I checked the rca&#039;s one at a time, and I took a grinder to the chassis and installed my ground with a 14 mm bolt. My gain is set to the head unit which is 2v. All the settings are set to the specs of my subs. I did one wire at a time too when trouble shooting. Checked if any wire was loose and they all appear pretty snug. All the diagnostics passed, but when the volume is up it still shut the amp off.Here are my Specs:Hifonics BXI 1606D Mono Class D amplifier2 12&quot;Coustic Crusher Single Voice Coil(225 watts RMS)Tsunami 5 Farad CapacitorAlpine CDA- 9883 Head UnitOptima Red Top BatteryDB-Link 0 Gauge WireScosche Double Braided 1600 watt RCA CablesScoshe 12 Gauge Speaker wireHopefully someone knows what&#039;s going on with my system, because i can&quot;t figure it out and it&#039;s really getting annoying. Someone please HELP!!!</blockquote>

[QUOTE="z-ham, post: 6288948, member: 614324"] My amp will play just fine at normal volumes, but when I turn it past 25 or more on the head unit it will play maybe for a bit depending on the bass on the song. If my bass hits hard then it will go into protect mode. I have checked everything to see if i have it wired right, and everything is a go. I've been on multiple sites and checked everything that is usually wrong with wiring. I have trouble shot it for a while and can"t seem to figure out what is wrong with my setup. I checked the rca's one at a time, and I took a grinder to the chassis and installed my ground with a 14 mm bolt. My gain is set to the head unit which is 2v. All the settings are set to the specs of my subs. I did one wire at a time too when trouble shooting. Checked if any wire was loose and they all appear pretty snug. All the diagnostics passed, but when the volume is up it still shut the amp off. Here are my Specs: Hifonics BXI 1606D Mono Class D amplifier 2 12"Coustic Crusher Single Voice Coil(225 watts RMS) Tsunami 5 Farad Capacitor Alpine CDA- 9883 Head Unit Optima Red Top Battery DB-Link 0 Gauge Wire Scosche Double Braided 1600 watt RCA Cables Scoshe 12 Gauge Speaker wire Hopefully someone knows what's going on with my system, because i can"t figure it out and it's really getting annoying. Someone please HELP!!! [/QUOTE]

Verification