Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp RMS Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="reible82nd" data-source="post: 7992275" data-attributes="member: 629602"><p>That amp will work those subs like a pimp works a hooker. Those PPI Art amps are amazing. Just run two subs to each side...on each sub, take the positive of one voice coil and connect it to the negative of the other voice coil. Then run the positive and negative left over on each sub to the amp...you should have 4 positives and 4 negatives after it's all said and done. Take the two subs on the right side and connect the two positives and negatives to the right output of the amp...do the same with the left side and you're good to go. 4 subs running 2 ohms stereo at 300x2. You may actually get some good imaging out of your subs running them stereo too. You'll enjoy it man.</p></blockquote><p></p>
[QUOTE="reible82nd, post: 7992275, member: 629602"] That amp will work those subs like a pimp works a hooker. Those PPI Art amps are amazing. Just run two subs to each side...on each sub, take the positive of one voice coil and connect it to the negative of the other voice coil. Then run the positive and negative left over on each sub to the amp...you should have 4 positives and 4 negatives after it's all said and done. Take the two subs on the right side and connect the two positives and negatives to the right output of the amp...do the same with the left side and you're good to go. 4 subs running 2 ohms stereo at 300x2. You may actually get some good imaging out of your subs running them stereo too. You'll enjoy it man. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp RMS Question
Top
Menu
Home
Refresh