Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp on, no sound
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="robertark" data-source="post: 6882946" data-attributes="member: 621407"><p>Hey guys,</p><p></p><p>I had these subs hooked up in my room before I took them out to my car. I have a Kinetik HC1800 that I used in my room and a spare deck. Wired it all up with 0ga wiring (pos to pos, neg to neg) and it worked. About blew my door down.</p><p></p><p>Now, I get it all outside, wired, perfect voltages, etc, and nothing. The subs are wired to the amp correctly and the amp comes on. No sound. Since it was in my car with a different deck, I figured it could be a bad deck or interconnects, so I brought out the old deck and hooked it up even using different interconnects. Still nothing. So, the amp is getting a signal in, but it's not putting anything out - at all.</p><p></p><p>Is there a way, with a voltmeter, to test the amp's mono out? Maybe even the resistance (ohms)?</p><p></p><p>I can't figure this out and I've been going at it for a while now. Suggestions would be great,</p><p></p><p>Rob</p></blockquote><p></p>
[QUOTE="robertark, post: 6882946, member: 621407"] Hey guys, I had these subs hooked up in my room before I took them out to my car. I have a Kinetik HC1800 that I used in my room and a spare deck. Wired it all up with 0ga wiring (pos to pos, neg to neg) and it worked. About blew my door down. Now, I get it all outside, wired, perfect voltages, etc, and nothing. The subs are wired to the amp correctly and the amp comes on. No sound. Since it was in my car with a different deck, I figured it could be a bad deck or interconnects, so I brought out the old deck and hooked it up even using different interconnects. Still nothing. So, the amp is getting a signal in, but it's not putting anything out - at all. Is there a way, with a voltmeter, to test the amp's mono out? Maybe even the resistance (ohms)? I can't figure this out and I've been going at it for a while now. Suggestions would be great, Rob [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp on, no sound
Top
Menu
Home
Refresh