Reply to thread

Message

<blockquote data-quote="bob1122" data-source="post: 7196194" data-attributes="member: 630119">Hey, I am new to CarAudio&#039;s forum&#039;s and thank you In advance for any help!I recently installed some rear speakers in my 92 Tercel and have noticed they are missing allot of power that they had in my previous car. I happened to have a buddy with a small extra amp he didn&#039;t need so I grabbed his Rockford Fosgate Punch120a (60 x 2 watts rms)&nbsp; and I would like to install it but have no idea how to go about doing this. (I assume the lack of power is because all I did was connect the speakers and have no increase the power going to them.The inputs on my amp are as follows:Left Input (RCA)Right input (RCA)High level Input (Have no idea what the connector is but it have R+R- and L+L-)REM (Just a single prong)Then I have the output:Left +Left -Right&nbsp; +Right -B +GNDTo start I assume I run a heavy guage wire from the pos terminal on my battery to the B + on the amp. I have no idea how to connect the input (Possibly solder rear right and left to RCA plugs respectivly? ), and where to run the ground wire. I also don&#039;t know what the REM is for and if its neccesary. There is also a Switch&nbsp; (120HP - full crossover- 80LP), Is there a specific setting I need to use?I am still using the stock radio is this going to be a issue (I plan to upgrade when I can afford too!)Thanks allot for any help !</blockquote>

[QUOTE="bob1122, post: 7196194, member: 630119"] Hey, I am new to CarAudio's forum's and thank you In advance for any help! I recently installed some rear speakers in my 92 Tercel and have noticed they are missing allot of power that they had in my previous car. I happened to have a buddy with a small extra amp he didn't need so I grabbed his Rockford Fosgate Punch120a (60 x 2 watts rms) and I would like to install it but have no idea how to go about doing this. (I assume the lack of power is because all I did was connect the speakers and have no increase the power going to them. The inputs on my amp are as follows: Left Input (RCA) Right input (RCA) High level Input (Have no idea what the connector is but it have R+R- and L+L-) REM (Just a single prong) Then I have the output: Left + Left - Right + Right - B + GND To start I assume I run a heavy guage wire from the pos terminal on my battery to the B + on the amp. I have no idea how to connect the input (Possibly solder rear right and left to RCA plugs respectivly? ), and where to run the ground wire. I also don't know what the REM is for and if its neccesary. There is also a Switch (120HP - full crossover- 80LP), Is there a specific setting I need to use? I am still using the stock radio is this going to be a issue (I plan to upgrade when I can afford too!) Thanks allot for any help ! [/QUOTE]

Verification