Reply to thread

Message

<blockquote data-quote="RainStryke" data-source="post: 7169118" data-attributes="member: 587930">Just an update:Went ahead and contacted the person I bought the subwoofer from and he seemed a bit skeptical about the problem, but he said to go ahead an send it back. He said it was the worst remanufactured kicker sub he&#039;s ever seen. The voice coil was not aligned... He went ahead and gave me 20 dollars and sent me a new one that he tested before sending out.But the AMP, that&#039;s another thing. I got the HiFonics 1000w AMP in place of my Soundstream 700w (This is the 3rd amp, all ready had two bad Soundstream 700w AMP&#039;s). On arrival the box had all ready been opened, the hifonics tape inside the box had been broken and the two stickers on the bottom that say &quot;Warranty void if broken or tampered with.&quot; both stickers are broken. I went ahead and installed it anyway to hear my&nbsp; new sub, sounds good but if I turn it up really loud my car reaks of melting electronics. I suppose I should take the sub down to a 4OHM load than a 1OHM. Anyway... Thanks to all that responded.</blockquote>

[QUOTE="RainStryke, post: 7169118, member: 587930"] Just an update: Went ahead and contacted the person I bought the subwoofer from and he seemed a bit skeptical about the problem, but he said to go ahead an send it back. He said it was the worst remanufactured kicker sub he's ever seen. The voice coil was not aligned... He went ahead and gave me 20 dollars and sent me a new one that he tested before sending out. But the AMP, that's another thing. I got the HiFonics 1000w AMP in place of my Soundstream 700w (This is the 3rd amp, all ready had two bad Soundstream 700w AMP's). On arrival the box had all ready been opened, the hifonics tape inside the box had been broken and the two stickers on the bottom that say "Warranty void if broken or tampered with." both stickers are broken. I went ahead and installed it anyway to hear my new sub, sounds good but if I turn it up really loud my car reaks of melting electronics. I suppose I should take the sub down to a 4OHM load than a 1OHM. Anyway... Thanks to all that responded. [/QUOTE]

Verification