Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp in protect mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Deiimos" data-source="post: 8808494" data-attributes="member: 682903"><p>He said in the first post he tried it with the rca cables and speakers unplugged and it’s still in protect, so impedance shouldn’t make any difference here. It should power on fine with just ground, B+, and remote.</p><p></p><p>He also made it seem like it never produced audio after the install, so impedance should not make a difference here either. Did it ever produce sound / bass?</p><p></p><p>What model is the amp? Does it have special sensing to detect impedance to tell itself to not power on? Most amps don’t have this and will play bass to a certain point even below rated impedance.</p></blockquote><p></p>
[QUOTE="Deiimos, post: 8808494, member: 682903"] He said in the first post he tried it with the rca cables and speakers unplugged and it’s still in protect, so impedance shouldn’t make any difference here. It should power on fine with just ground, B+, and remote. He also made it seem like it never produced audio after the install, so impedance should not make a difference here either. Did it ever produce sound / bass? What model is the amp? Does it have special sensing to detect impedance to tell itself to not power on? Most amps don’t have this and will play bass to a certain point even below rated impedance. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp in protect mode
Top
Menu
What's new
Forum list
