Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Amp going into protection
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jbizzle" data-source="post: 4433919" data-attributes="member: 579181"><p>I just got my system installed yesterday, after bumpin it a bit, my amp went into thermal protection. At first I thought it was a fuse (i had a 150 amp) then I switched it to a 250 amp.</p><p></p><p>I touched the amp and it was really hot, I saw the light on the bottom say THERMAL. It is because my loss of voltage? I've been having a real big problem with power which i'm trying to upgrade it asap.</p><p></p><p>AMP: MTX TA81001</p><p></p><p>SUBS: 2 12" MTX 9500's DVC4</p><p></p><p>Final load on the amp is 1 ohm, and it is 1 ohm stable.. HELP PLZ!!</p><p></p><p>also, it turns back on just about 2-5 minutes later, but after bumping again it goes into protection, over and over..</p></blockquote><p></p>
[QUOTE="jbizzle, post: 4433919, member: 579181"] I just got my system installed yesterday, after bumpin it a bit, my amp went into thermal protection. At first I thought it was a fuse (i had a 150 amp) then I switched it to a 250 amp. I touched the amp and it was really hot, I saw the light on the bottom say THERMAL. It is because my loss of voltage? I've been having a real big problem with power which i'm trying to upgrade it asap. AMP: MTX TA81001 SUBS: 2 12" MTX 9500's DVC4 Final load on the amp is 1 ohm, and it is 1 ohm stable.. HELP PLZ!! also, it turns back on just about 2-5 minutes later, but after bumping again it goes into protection, over and over.. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Amp going into protection
Top
Menu
What's new
Forum list
