Reply to thread

Message: <blockquote data-quote="waccord99" data-source="post: 6160387" data-attributes="member: 605527">well basically i ordered to new amps and they went into protect mode.......i was about to send them back but then i hooked them into my friends car and they worked 100 percent......so i figure there is something up with my wiring i take out a dmm and i read the output at the battery 11 volts on a cheap radioshack dmm.  i hit 11 volts all the way past the fuse in the front and past the distribution block in the back that spits to the amps....well when i hooked the dmm to the leads on the amp it read 4 volts....so im guessing its in protect because the volts are to low but i cant figure out why they are so low and why the amp is going into protect mode instantly.By the way the grounds are good because i hooked them up the dmm while also using the power wires and its gave me 11 volts of output....also the remote wire was reading out 11 volts.....</blockquote>

Top