Reply to thread

Message

<blockquote data-quote="exige" data-source="post: 2941104" data-attributes="member: 574417">sry i should clarify....the sub can be either 2 ohm or 4 ohm.&nbsp; ill choose based off the amp.the us amps would run bridged and do 1000x1@4ohms.&nbsp; ive heard these are quite underrated but im not entirely sure.the eD would run normal and do 900x1@2ohms at 12.5v.&nbsp; i would assume about 1000w at 14.4v.so if theres any difference between the two....it wont be audible in terms of output.&nbsp; they should really both be about the same.&nbsp; i no a 4 ohm load is easier on an amp...but doesnt bridging an amp make that load just as hard on the amp?&nbsp; im not all that concerned about the warranty...eD&#039;s runs out a month or two from now.&nbsp; the us amps doesnt have one but has been turned on and works.&nbsp; i would assume the us amps quality is gonna be much better...but the nine.1 is workhorse.&nbsp; so each side has its own advantages.&nbsp; based off of this stuff that i&#039;ve just added, what would you choose?</blockquote>

[QUOTE="exige, post: 2941104, member: 574417"] sry i should clarify.... the sub can be either 2 ohm or 4 ohm. ill choose based off the amp. the us amps would run bridged and do 1000x1@4ohms. ive heard these are quite underrated but im not entirely sure. the eD would run normal and do 900x1@2ohms at 12.5v. i would assume about 1000w at 14.4v. so if theres any difference between the two....it wont be audible in terms of output. they should really both be about the same. i no a 4 ohm load is easier on an amp...but doesnt bridging an amp make that load just as hard on the amp? im not all that concerned about the warranty...eD's runs out a month or two from now. the us amps doesnt have one but has been turned on and works. i would assume the us amps quality is gonna be much better...but the nine.1 is workhorse. so each side has its own advantages. based off of this stuff that i've just added, what would you choose? [/QUOTE]

Verification