Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp controls, explain please.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ANeonRider" data-source="post: 743886" data-attributes="member: 556161"><p>gain = matches the pre-amp output from the HU to the input of the amp</p><p></p><p>bass boost = boosts the signal at a certain frequency (usually 45Hz). Also known as the woofer cooker, unless you know what you are doing, leave this one at 0.</p><p></p><p>Crossover/Filter = Filters the signal that is reproduced, if it is a low pass filter, filters the frequencies below the set frequency at a set slope (6dB/octave, 12dB/octave, etc)</p><p></p><p>Check out the sticky at the top of the amplifier section on how to set the gain, or you will most likely fry another sub.</p></blockquote><p></p>
[QUOTE="ANeonRider, post: 743886, member: 556161"] gain = matches the pre-amp output from the HU to the input of the amp bass boost = boosts the signal at a certain frequency (usually 45Hz). Also known as the woofer cooker, unless you know what you are doing, leave this one at 0. Crossover/Filter = Filters the signal that is reproduced, if it is a low pass filter, filters the frequencies below the set frequency at a set slope (6dB/octave, 12dB/octave, etc) Check out the sticky at the top of the amplifier section on how to set the gain, or you will most likely fry another sub. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp controls, explain please.
Top
Menu
What's new
Forum list
