Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Head Units
Alpine CDA 9887 questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="99StangGt" data-source="post: 3663191" data-attributes="member: 560116"><p>Well I have a 150rms amp running 2 Nakamichi subs and when cranked it will make the rear view mirror turn down and look at the floor. Turn off the amps crossover, use the one in the deck. In the crossover setting there should be an adjustment for the output of the sub and in the standard menu there is another adjustment. I know this sounds stupid but make sure the sub is turned on in the setup menu on the deck. I dont have that deck but I do have a 9835 that is very close to that one. What kind of sub is it? Need to know if its a single voice coil or dual. Also need to know the ohms rating of the voice coil. When bridging you use the positive on one side and the negative on the other side. Just make sure it wont be lower then 4 ohms unless you have an amp that will do lower bridged.</p></blockquote><p></p>
[QUOTE="99StangGt, post: 3663191, member: 560116"] Well I have a 150rms amp running 2 Nakamichi subs and when cranked it will make the rear view mirror turn down and look at the floor. Turn off the amps crossover, use the one in the deck. In the crossover setting there should be an adjustment for the output of the sub and in the standard menu there is another adjustment. I know this sounds stupid but make sure the sub is turned on in the setup menu on the deck. I dont have that deck but I do have a 9835 that is very close to that one. What kind of sub is it? Need to know if its a single voice coil or dual. Also need to know the ohms rating of the voice coil. When bridging you use the positive on one side and the negative on the other side. Just make sure it wont be lower then 4 ohms unless you have an amp that will do lower bridged. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Head Units
Alpine CDA 9887 questions
Top
Menu
What's new
Forum list