Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Head Units
Alpine CDA-9887 and crossovers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jaysexxin" data-source="post: 7365210" data-attributes="member: 578594"><p>Good morning,</p><p></p><p>The alpine has dip switch on the chassis for 2 xover settings; 2way and 3way. What is the best way to setup the deck with the equipment I have? Can I even do 3 way?</p><p></p><p>Here is my setup for the speakers. I only have 1 set of speakers (i only have room for 1 set)</p><p></p><p>Viper 550.2 components (100 RMS) - powered by MRP-F240</p><p></p><p>MRP-F240</p><p></p><p>40 watts RMS x 4 at 4 ohms</p><p></p><p>50 watts RMS x 4 at 2 ohms</p><p></p><p>100 watts RMS x 2 bridged output at 4 ohms</p><p></p><p>I was going to bridge and have the set run at 100 watts.</p><p></p><p>Thanks in advance</p></blockquote><p></p>
[QUOTE="jaysexxin, post: 7365210, member: 578594"] Good morning, The alpine has dip switch on the chassis for 2 xover settings; 2way and 3way. What is the best way to setup the deck with the equipment I have? Can I even do 3 way? Here is my setup for the speakers. I only have 1 set of speakers (i only have room for 1 set) Viper 550.2 components (100 RMS) - powered by MRP-F240 MRP-F240 40 watts RMS x 4 at 4 ohms 50 watts RMS x 4 at 2 ohms 100 watts RMS x 2 bridged output at 4 ohms I was going to bridge and have the set run at 100 watts. Thanks in advance [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Head Units
Alpine CDA-9887 and crossovers
Top
Menu
What's new
Forum list
