Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Head Units
Alpine CDA-9835 Users..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="juukno" data-source="post: 5950911" data-attributes="member: 600357"><p>I am having quite a bit of difficulty trying to figure out whether or not my amp is going into protect mode due to the settings I have. In the front I have all stock speakers/components. In the back I have 1 15" 2500W sub/2500W mono amp. I have read in the past that this HU doesn't exert the correct subout voltage until the subwoofer level is at +15. This, on the other hand, is putting my amp into protect mode.</p><p></p><p>My question is what is the correct settings for this HU in a single high powered setup? And, what might be throwing my amp into protect (i set the gains with a DMM and have them wired correctly)? Thanks for any help</p></blockquote><p></p>
[QUOTE="juukno, post: 5950911, member: 600357"] I am having quite a bit of difficulty trying to figure out whether or not my amp is going into protect mode due to the settings I have. In the front I have all stock speakers/components. In the back I have 1 15" 2500W sub/2500W mono amp. I have read in the past that this HU doesn't exert the correct subout voltage until the subwoofer level is at +15. This, on the other hand, is putting my amp into protect mode. My question is what is the correct settings for this HU in a single high powered setup? And, what might be throwing my amp into protect (i set the gains with a DMM and have them wired correctly)? Thanks for any help [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Head Units
Alpine CDA-9835 Users..
Top
Menu
What's new
Forum list
