Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Alpine Amps.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ninjatek" data-source="post: 2800065" data-attributes="member: 568991"><p>yea, i have that amp and it rocks. only problem is, I've been using it in 4 channel mode in a 70x4 setup. I just got a set of new components, and im now bridging the amp into 200x2. My impedences are correct, but at moderately high volumes, my amp is going into protect mode. its getting really hot. it is sitting in good airspace so its not covered or anything</p><p></p><p>I cranked it up all the time in 70x4 and never had a problem, never shut it down, never blew a fuse, but now that I bridged it, it keeps going into protect mode.. connections are good, no noticiable line noise, and it will rock out at high volume for about 10 minutes (with no distortion) but after that it seems to get to hot and shuts down. gain is set at nominal (dead center at 0)</p><p></p><p>I was getting ready to start a post about it and saw this and noticed you were looking at the same amp. It sounds really good, very musical, looks nice, and is well built. I'm not throwing in the towel just yet, because I'm not a professional installer..</p></blockquote><p></p>
[QUOTE="ninjatek, post: 2800065, member: 568991"] yea, i have that amp and it rocks. only problem is, I've been using it in 4 channel mode in a 70x4 setup. I just got a set of new components, and im now bridging the amp into 200x2. My impedences are correct, but at moderately high volumes, my amp is going into protect mode. its getting really hot. it is sitting in good airspace so its not covered or anything I cranked it up all the time in 70x4 and never had a problem, never shut it down, never blew a fuse, but now that I bridged it, it keeps going into protect mode.. connections are good, no noticiable line noise, and it will rock out at high volume for about 10 minutes (with no distortion) but after that it seems to get to hot and shuts down. gain is set at nominal (dead center at 0) I was getting ready to start a post about it and saw this and noticed you were looking at the same amp. It sounds really good, very musical, looks nice, and is well built. I'm not throwing in the towel just yet, because I'm not a professional installer.. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Alpine Amps.
Top
Menu
What's new
Forum list