Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Aero/square port question.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="SpeedEuphoria" data-source="post: 7055233" data-attributes="member: 623992"><p>the only thing I can tell you from looking into velocity stacks/bellmouths for use in internal combustion engines is that I believe the bell mouth works better if its raised off the surface. It scavenges air better IIRC</p><p></p><p>So it would work better if not mounted to the box on either side(neither flare touching the box wall), so the flare is extended into or out of the box at least 1" or a couple inches on both sides.</p><p></p><p>As far as internal or external shouldn't matter, as long as following the above. Just more available internal box volume with an external port</p></blockquote><p></p>
[QUOTE="SpeedEuphoria, post: 7055233, member: 623992"] the only thing I can tell you from looking into velocity stacks/bellmouths for use in internal combustion engines is that I believe the bell mouth works better if its raised off the surface. It scavenges air better IIRC So it would work better if not mounted to the box on either side(neither flare touching the box wall), so the flare is extended into or out of the box at least 1" or a couple inches on both sides. As far as internal or external shouldn't matter, as long as following the above. Just more available internal box volume with an external port [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Aero/square port question.
Top
Menu
What's new
Forum list
