Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Advice on wiring method for this setup.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="namomaitreya" data-source="post: 5723746" data-attributes="member: 607887"><p>I have two Memphis 12" 15-PR12D4 DVC 4-ohm. And a Memphis MC 16-MC1.500. The speakers are 250/500 and the amp is capable of 125W@4ohm 250W@2ohm and 500W@1ohm. I was planning to wire them @1ohm. By attaching the ++ and -- on each speaker and taking a second wire from the +- from one voice coil on each speaker to each cup. Then attaching the cups together and running a wire to the single set of inputs on the amp. Is this the correct method? Will I be overpowering my subs? I'm really learning as I go new to DIY. Thanks for any input.</p></blockquote><p></p>
[QUOTE="namomaitreya, post: 5723746, member: 607887"] I have two Memphis 12" 15-PR12D4 DVC 4-ohm. And a Memphis MC 16-MC1.500. The speakers are 250/500 and the amp is capable of 125W@4ohm 250W@2ohm and 500W@1ohm. I was planning to wire them @1ohm. By attaching the ++ and -- on each speaker and taking a second wire from the +- from one voice coil on each speaker to each cup. Then attaching the cups together and running a wire to the single set of inputs on the amp. Is this the correct method? Will I be overpowering my subs? I'm really learning as I go new to DIY. Thanks for any input. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Advice on wiring method for this setup.
Top
Menu
What's new
Forum list
