Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
Active X-over set-up Q?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="fossil99ca" data-source="post: 1015045" data-attributes="member: 554480"><p>Thanks Squeak for the read. I believe I get it.</p><p></p><p>In other words, set the gain on the x-over as high as possible and the gain on the amp as low as possible. This way only the signal noise of the x-over and HU is amplified and not the signal noise of all three, HU, x-over and amp are amplified.</p><p></p><p>Ideally you would want both gains at a minimum sensitivity so you are only amplifying the signal noise from the HU but in practice this would almost be impossible.</p><p></p><p>Gives me a place to start when doing setup. Start with both gains low and then start turning the gain on the x-over up until desired level.</p><p></p><p>Correct me if I am wrong.</p></blockquote><p></p>
[QUOTE="fossil99ca, post: 1015045, member: 554480"] Thanks Squeak for the read. I believe I get it. In other words, set the gain on the x-over as high as possible and the gain on the amp as low as possible. This way only the signal noise of the x-over and HU is amplified and not the signal noise of all three, HU, x-over and amp are amplified. Ideally you would want both gains at a minimum sensitivity so you are only amplifying the signal noise from the HU but in practice this would almost be impossible. Gives me a place to start when doing setup. Start with both gains low and then start turning the gain on the x-over up until desired level. Correct me if I am wrong. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
Active X-over set-up Q?
Top
Menu
What's new
Forum list
