Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
A few amplifier questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="giventofly" data-source="post: 3133577" data-attributes="member: 578012"><p>I have a Memphis Baby Belle MCH600 (4 x 55W @ 4ohms, 150W @ 4 ohms bridged), and am gonna use it to power a either 1 or 2 pairs of comps) and a 12" sub. I was planning on getting a pair of nice comps like some:</p><p></p><p>CDT Audio CL61</p><p></p><p>MB Quart PCE216's</p><p></p><p>RE audio RE6.5comps</p><p></p><p>Focal Access components(165A1)</p><p></p><p>Phoenix Golds(RSD65CS)</p><p></p><p>and then a pair of cheaper comps or coaxials for the back.</p><p></p><p>My question is: whats the best way to wire this system? I was gonna bridge the first two channels to run the front stage at 150W and then run a dual voice coil sub at 2 ohms/200W ,and the rear stage from the head unit power.</p><p></p><p>Any other suggestions or comments? I am a newbie and really am learning as i go along.</p></blockquote><p></p>
[QUOTE="giventofly, post: 3133577, member: 578012"] I have a Memphis Baby Belle MCH600 (4 x 55W @ 4ohms, 150W @ 4 ohms bridged), and am gonna use it to power a either 1 or 2 pairs of comps) and a 12" sub. I was planning on getting a pair of nice comps like some: CDT Audio CL61 MB Quart PCE216's RE audio RE6.5comps Focal Access components(165A1) Phoenix Golds(RSD65CS) and then a pair of cheaper comps or coaxials for the back. My question is: whats the best way to wire this system? I was gonna bridge the first two channels to run the front stage at 150W and then run a dual voice coil sub at 2 ohms/200W ,and the rear stage from the head unit power. Any other suggestions or comments? I am a newbie and really am learning as i go along. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
A few amplifier questions
Top
Menu
What's new
Forum list
