Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Builds
Car Audio Build Logs
'99 Jeep TJ audio project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="TommyK" data-source="post: 8873944" data-attributes="member: 691154"><p>Here's how I mounted the sub amp under the driver's seat. It's a nice fit. Trying to keep everything hidden and rain ready...the head unit power amp is under the steering column and I'm undecided about the 4 channel amp but it's currently going under the rear seat. I ran 1ga wire to the center console into a distribution block then stepped down to 4 ga to power the two amps. The same size wire for the grounds. I put a bolt in the same console area in the floor, by the distribution block, and connected the grounds to it and it's connected directly to the frame and chasis.</p></blockquote><p></p>
[QUOTE="TommyK, post: 8873944, member: 691154"] Here's how I mounted the sub amp under the driver's seat. It's a nice fit. Trying to keep everything hidden and rain ready...the head unit power amp is under the steering column and I'm undecided about the 4 channel amp but it's currently going under the rear seat. I ran 1ga wire to the center console into a distribution block then stepped down to 4 ga to power the two amps. The same size wire for the grounds. I put a bolt in the same console area in the floor, by the distribution block, and connected the grounds to it and it's connected directly to the frame and chasis. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Builds
Car Audio Build Logs
'99 Jeep TJ audio project
Top
Menu
What's new
Forum list