Reply to thread

Message: <blockquote data-quote="The Camry" data-source="post: 8531225" data-attributes="member: 657974">I got my DSO Nano in the mail today. FinallySo i did some testing on my 80prs and the c-dsp. I have my mid channel sending a full range single from the 80prs to the C-dsp. All boost was introduced through the 16 band Eq.tested freq were100hz 0db tone1000hz 0db tone10khz 0db tone62/62 volume. flat eq no clipping any freq100hz tone. 80hz +1db 125hz +1db boost. clipping at 62 volume100hz 80hz +1db 125hz +1db no clipping at 61 volume100hz 80hz +6db 125hz +6db 54 no clipping(55 had clipping)1000hz flat no clipping 62 volume.1000hz 800 +1db boost 1250 +1db boost clipping at 62 volume.1000hz 800 +6db boost 1250 +6db boost no clipping at 54 volume(clipping at 55)same for 10khz ^^^80prs output voltageVolume voltage62 4.72v61 3.76v60 2.96vDrops off rapidly after 57 or so.C-dspright side and left side input. both had identical results."boost" was introduced on C-dsp input volume100 hz tone1.88volts at +1db boost1.76v at 0db 100hz test tone.2volts at 2db boost clipping1.96v at 1.5db boost soft clipI did not look at voltages for 1 and 10khz but clipping was at the same points.So, the 80Prs has a clean output all the way through its volume knob even to max. The C-dsp input can take about 3.8 volts(61/62 on 80prs) of input before clipping. It can put out around 1.88volts at +1db boost on input volume knob. Any more boost will result in a clipped signal.</blockquote>

Top