Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
????????
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Randy 5.3" data-source="post: 7144675" data-attributes="member: 628624"><p>Hey guys, I'm new to this forum, hoping to learn a few things from the experts on wiring systems.......I have my first quick question or problem rather, I bought a pair of 10" Kicker CVXs, 1200watts (600 rms), dual voice coil (2 Ohms each, 4 TOTAL OHMS) and am hooked them up to my old school Memphis 16-st 1000.1 class D amp. I wired my subs to lower them down to 2 Ohms but did not bridge them at the amp. On my first start up, I tried pushing the subs and the amp started clipping (or so I THINK it's CLIPPING, a sort of TAPPING noise was heard along with the bass), anyways, long story short, why would the amp be doing this if it should have more than enough power to fire up these subs? How many OHMS is the amp working on?</p><p></p><p>Again totally new to this so any help is greatly appreciated.</p><p></p><p>-Randy-</p></blockquote><p></p>
[QUOTE="Randy 5.3, post: 7144675, member: 628624"] Hey guys, I'm new to this forum, hoping to learn a few things from the experts on wiring systems.......I have my first quick question or problem rather, I bought a pair of 10" Kicker CVXs, 1200watts (600 rms), dual voice coil (2 Ohms each, 4 TOTAL OHMS) and am hooked them up to my old school Memphis 16-st 1000.1 class D amp. I wired my subs to lower them down to 2 Ohms but did not bridge them at the amp. On my first start up, I tried pushing the subs and the amp started clipping (or so I THINK it's CLIPPING, a sort of TAPPING noise was heard along with the bass), anyways, long story short, why would the amp be doing this if it should have more than enough power to fire up these subs? How many OHMS is the amp working on? Again totally new to this so any help is greatly appreciated. -Randy- [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
????????
Top
Menu
What's new
Forum list
