Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
4 channel amp to 4 4 ohm speaker
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mxrider125" data-source="post: 8853503" data-attributes="member: 689525"><p>Hey everyone,</p><p></p><p>My brain is fried right now trying to figure this ou and is probably a dumb qs. Anyway if I have a 4 channel amp rated for 250w at 2ohms x4 or 125w at 4ohms x4, I’m trying to wire my 4 4ohm KENWOOD 6x9 speakers at 4ohm impedance.. for the ratings on the amp is that implying I can just run each speaker to each channel and it would be at 4ohms across the board on each channel like I think It should? Or do I have to bridge for the 4ohms? Which doesn’t make sense in my head.. idk if I’m just dumb or overthinking it by a lot lol</p></blockquote><p></p>
[QUOTE="mxrider125, post: 8853503, member: 689525"] Hey everyone, My brain is fried right now trying to figure this ou and is probably a dumb qs. Anyway if I have a 4 channel amp rated for 250w at 2ohms x4 or 125w at 4ohms x4, I’m trying to wire my 4 4ohm KENWOOD 6x9 speakers at 4ohm impedance.. for the ratings on the amp is that implying I can just run each speaker to each channel and it would be at 4ohms across the board on each channel like I think It should? Or do I have to bridge for the 4ohms? Which doesn’t make sense in my head.. idk if I’m just dumb or overthinking it by a lot lol [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
4 channel amp to 4 4 ohm speaker
Top
Menu
Home
Refresh