Reply to thread

Message

<blockquote data-quote="edeekeos" data-source="post: 2067054" data-attributes="member: 570029">Ok, i have a 4 channel MTX amp(Thunder 4200x), and i am wanting to push a DVC sub(Kicker Solo Baric DVC 2ohm) is it ok(SAFE) to hook up channels 1 &amp;amp; 2(Bridged) to one coil, and 3 &amp;amp; 4(bridged) to the other coil. and obviously the same signals being sent to all of the channels. Does anyone know, or can i get a diagram, or any information at all??.........i have not yet purchased the sub yet, so if needed i can order the Dual 4 ohm model instead of the dual 2 ohm model...the specs on the amp are.....Specs:25 Watts RMS/CH x 4 into 4 ohms50 Watts RMS/CH X 4 into 2 Ohms100 Watts RMS Bridged X 2 into 4 Ohms200 Watts Dynamic Power (IHF-202) Bridged into 4 Ohms (14.4 VDC)RMS Power Ratings @ 12.5 VDC, Hz-20KHzFeatures:Left &amp;amp; Right Rear Gain ControlThunder EQ Control 0 to +18dB @ 40HzCrossover Frequency 50 - 200HzCrossover ON/OFFCrossover HP/LPRear Left and Right Input RCA JackSummed Left and Right Output RCA JackFront Left and Right Input RCA JackThis amplifier can operate in Bridged and Stereo modes simultaneously.</blockquote>

[QUOTE="edeekeos, post: 2067054, member: 570029"] Ok, i have a 4 channel MTX amp(Thunder 4200x), and i am wanting to push a DVC sub(Kicker Solo Baric DVC 2ohm) is it ok(SAFE) to hook up channels 1 & 2(Bridged) to one coil, and 3 & 4(bridged) to the other coil. and obviously the same signals being sent to all of the channels. Does anyone know, or can i get a diagram, or any information at all??.........i have not yet purchased the sub yet, so if needed i can order the Dual 4 ohm model instead of the dual 2 ohm model...the specs on the amp are..... Specs: 25 Watts RMS/CH x 4 into 4 ohms 50 Watts RMS/CH X 4 into 2 Ohms 100 Watts RMS Bridged X 2 into 4 Ohms 200 Watts Dynamic Power (IHF-202) Bridged into 4 Ohms (14.4 VDC) RMS Power Ratings @ 12.5 VDC, Hz-20KHz Features: Left & Right Rear Gain Control Thunder EQ Control 0 to +18dB @ 40Hz Crossover Frequency 50 - 200Hz Crossover ON/OFF Crossover HP/LP Rear Left and Right Input RCA Jack Summed Left and Right Output RCA Jack Front Left and Right Input RCA Jack This amplifier can operate in Bridged and Stereo modes simultaneously. [/QUOTE]

Verification