Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
3 way speaker setup....active....passive ???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Why So Cereal?" data-source="post: 7350418" data-attributes="member: 626047"><p>Apparently i've been listening to the Mark Levinson system in this Lexus LS460 for too long and I'm addicted. I think its a 3 way setup. The mid and tweeter are on the dash and there is a 6x9 (?) in the front doors that plays alot of bass. I want to do something similar in my tC but without fabricating a new dash. I have kickpanels. I was thinking of moving my current components to the kicks and putting a midbass in the door. But...I'm a noob so Idk where to go from here. How would I keep the components at 400hz (below this my components distort at high volume) and above? How do i keep the midbass from going into their range? The only idea i had was a 6 channel amp (so i can run my rear speakers too) but i'm not even sure that will work. Need help!!</p><p></p><p>OPEN TO ALL SUGGESTIONS!! and even offers on things f/s I can use to do this with!</p></blockquote><p></p>
[QUOTE="Why So Cereal?, post: 7350418, member: 626047"] Apparently i've been listening to the Mark Levinson system in this Lexus LS460 for too long and I'm addicted. I think its a 3 way setup. The mid and tweeter are on the dash and there is a 6x9 (?) in the front doors that plays alot of bass. I want to do something similar in my tC but without fabricating a new dash. I have kickpanels. I was thinking of moving my current components to the kicks and putting a midbass in the door. But...I'm a noob so Idk where to go from here. How would I keep the components at 400hz (below this my components distort at high volume) and above? How do i keep the midbass from going into their range? The only idea i had was a 6 channel amp (so i can run my rear speakers too) but i'm not even sure that will work. Need help!! OPEN TO ALL SUGGESTIONS!! and even offers on things f/s I can use to do this with! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
3 way speaker setup....active....passive ???
Top
Menu
What's new
Forum list