Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
3 way bridge or bi amp?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="614Emil" data-source="post: 8696187" data-attributes="member: 678762"><p>Hi! </p><p>I just got a set of kx3's that runs on a jbl px300.4 </p><p></p><p>125 rms 4 ohm x4</p><p>165 rms 2 ohm x4</p><p>Or</p><p>360 rms 4 ohm x2</p><p></p><p>Right now the kx3's are on front 2ch and focal ps165 on rear ch. </p><p></p><p>I also got another jbl px300.4 with defect front channels. </p><p>I was thinking of running the kx3's on only 1 amp but should i bridge and get 2 channels? That way i dont have to match adjust gain before the microphone taa. </p><p>Or</p><p>Run midrange and tweeter on front ch and midbass on rear ch?</p></blockquote><p></p>
[QUOTE="614Emil, post: 8696187, member: 678762"] Hi! I just got a set of kx3's that runs on a jbl px300.4 125 rms 4 ohm x4 165 rms 2 ohm x4 Or 360 rms 4 ohm x2 Right now the kx3's are on front 2ch and focal ps165 on rear ch. I also got another jbl px300.4 with defect front channels. I was thinking of running the kx3's on only 1 amp but should i bridge and get 2 channels? That way i dont have to match adjust gain before the microphone taa. Or Run midrange and tweeter on front ch and midbass on rear ch? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
3 way bridge or bi amp?
Top
Menu
Home
Refresh