Reply to thread

Message

<blockquote data-quote="Tim Burdeshaw" data-source="post: 8658340" data-attributes="member: 675732">Hope someone can help with my new install? I am on a tight budget and I know that two pair of the current speakers are crap and will be replaced later. So far I have $125 invested.Components :Pioneer MVH-S600BSAlpine MVR-F352Speakers:VR3 6X9s 3 ways 100 wattEmerson 4 &quot; 2 ways 70 watt (LOL! I know.)Planet Audio 12&quot; Dual voice coil 4 ohms 1800 watt Peak. RMS unknown? In a box I built to manufacturers specs I am having problems getting everything tuned to where it sounds decent at volume. I have a crossover in the stereo and the crossover on the amp. I was told to use only one of them and not both.because of phase distortion.  I wired the sub parallel @ 2 ohms. I amp using the amp to run the 2 6x9s and sub in a 3 channel  configuration and the 4s in the dash are running off the head unit. My phone has an EQ. My stereo has an EQ. Which one do I use and what do I set the other at? Same for the crossovers? Any advice would be greatly appreciated!</blockquote>

[QUOTE="Tim Burdeshaw, post: 8658340, member: 675732"] Hope someone can help with my new install? I am on a tight budget and I know that two pair of the current speakers are crap and will be replaced later. So far I have $125 invested. Components : Pioneer MVH-S600BS Alpine MVR-F352 Speakers: VR3 6X9s 3 ways 100 watt Emerson 4 " 2 ways 70 watt (LOL! I know.) Planet Audio 12" Dual voice coil 4 ohms 1800 watt Peak. RMS unknown? In a box I built to manufacturers specs I am having problems getting everything tuned to where it sounds decent at volume. I have a crossover in the stereo and the crossover on the amp. I was told to use only one of them and not both.because of phase distortion. I wired the sub parallel @ 2 ohms. I amp using the amp to run the 2 6x9s and sub in a 3 channel configuration and the 4s in the dash are running off the head unit. My phone has an EQ. My stereo has an EQ. Which one do I use and what do I set the other at? Same for the crossovers? Any advice would be greatly appreciated! [/QUOTE]

Verification