Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
3 amp setup
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="tweet02" data-source="post: 2308776" data-attributes="member: 567249"><p>Ok, Im going to put 2 Massive Audio P1500d, and 1 Kicker KX800x4. My question here is what type of electrical system work needs to be done. Here is what I have in my 97 Ford Explorer. I recently had a Autotek MX5000, and the same Kicker amp mentioned above. The Autotek was pushing [4] kicker L7's wired at 2ohms, doing 2400kw. I had it installed at local shop here in miami. I have 2 guage wire from the front to the back for my power line, same for the ground wire, also have a Redtop Bat in the rear by my sub box. None of the wires have changed sinc the insatll was done, but adding a 3rd amp, do i need to add another red/yellow top batt, or would my setup take on 3rd amp the way it is. Any help here would be greatly appreciated!!</p></blockquote><p></p>
[QUOTE="tweet02, post: 2308776, member: 567249"] Ok, Im going to put 2 Massive Audio P1500d, and 1 Kicker KX800x4. My question here is what type of electrical system work needs to be done. Here is what I have in my 97 Ford Explorer. I recently had a Autotek MX5000, and the same Kicker amp mentioned above. The Autotek was pushing [4] kicker L7's wired at 2ohms, doing 2400kw. I had it installed at local shop here in miami. I have 2 guage wire from the front to the back for my power line, same for the ground wire, also have a Redtop Bat in the rear by my sub box. None of the wires have changed sinc the insatll was done, but adding a 3rd amp, do i need to add another red/yellow top batt, or would my setup take on 3rd amp the way it is. Any help here would be greatly appreciated!! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
3 amp setup
Top
Menu
What's new
Forum list