Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
2008 G35s Sedan build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Nut Hair Trick" data-source="post: 7625431" data-attributes="member: 610343"><p>Yeah, made them myself. I bought the wooden balls from Michael's, when rang up at the register they are called "doll heads". I put them in the vice and used a 2 1/8" hole saw to get the outside dia, then a 1 3/4" holesaw for the inner edge of the pod. I found a "router" dremel tool to eliminate everything inside the inner circle. It worked pretty well, but I'm sure there are other ways to do it. About 5 light coats of VHT Caliper paint and a couple light coats of clear. Oh yeah, I drilled a 3/8 inch hole in the side to run the threaded brass into the spheres. They are made for lighting fixtures. The nuts to mount them should be in the same section.</p></blockquote><p></p>
[QUOTE="Nut Hair Trick, post: 7625431, member: 610343"] Yeah, made them myself. I bought the wooden balls from Michael's, when rang up at the register they are called "doll heads". I put them in the vice and used a 2 1/8" hole saw to get the outside dia, then a 1 3/4" holesaw for the inner edge of the pod. I found a "router" dremel tool to eliminate everything inside the inner circle. It worked pretty well, but I'm sure there are other ways to do it. About 5 light coats of VHT Caliper paint and a couple light coats of clear. Oh yeah, I drilled a 3/8 inch hole in the side to run the threaded brass into the spheres. They are made for lighting fixtures. The nuts to mount them should be in the same section. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
2008 G35s Sedan build
Top
Menu
Home
Refresh