Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
2008 G35s Sedan build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Nut Hair Trick" data-source="post: 7604640" data-attributes="member: 610343"><p>Because I'm running 2 batteries. One up front and one in the trunk. Power and ground ran parallel from battery to battery. The rear battery will pretty much be the power and ground distribution block. Yes, I've had trim and carpet all over my garage for the past few months, back in, back out, back in. Now, it's just pretty much all of the contents of my trunk that's gutted. The front stage amps are hooked up, and the HATS sound wonderful. Best component set I have ever owned. But then again, all I have ever dealt with before was Pioneer, JL Audio, and MB Quart(when it was good).</p><p></p><p>I need to set my gains for my mids but I'm not sure which test tone to use. Always before, I have used 1000hz test tones to set my front stage gains with a DMM. Well, that was with components running off the same amp. My mids and tweets are separate and I'm thinking I am supposed to go with a 500hz test tone for my mid amp but I'm not sure.</p></blockquote><p></p>
[QUOTE="Nut Hair Trick, post: 7604640, member: 610343"] Because I'm running 2 batteries. One up front and one in the trunk. Power and ground ran parallel from battery to battery. The rear battery will pretty much be the power and ground distribution block. Yes, I've had trim and carpet all over my garage for the past few months, back in, back out, back in. Now, it's just pretty much all of the contents of my trunk that's gutted. The front stage amps are hooked up, and the HATS sound wonderful. Best component set I have ever owned. But then again, all I have ever dealt with before was Pioneer, JL Audio, and MB Quart(when it was good). I need to set my gains for my mids but I'm not sure which test tone to use. Always before, I have used 1000hz test tones to set my front stage gains with a DMM. Well, that was with components running off the same amp. My mids and tweets are separate and I'm thinking I am supposed to go with a 500hz test tone for my mid amp but I'm not sure. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
2008 G35s Sedan build
Top
Menu
Home
Refresh