Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
2006 Dodge Rims, Tires and Stereo Build (Pictures)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mil81" data-source="post: 4885464" data-attributes="member: 590578"><p>As I said above, I was moving the piece in the correct direction. I know that for sure. When it caught my hand was well over a foot away from the bit. You are correct about holding the piece though. I was holding the piece between my fingers and thumb. Obviously with quite a tight grip. I will take your advice next time and keep my fingers tucked under my hand. Thanks.</p><p></p><p>I guess I will have to remake my template next time I go to build one of these, and make more careful cuts to ensure everything is quite close. My next purchase is a spiral up-cut bit too I guess.</p></blockquote><p></p>
[QUOTE="mil81, post: 4885464, member: 590578"] As I said above, I was moving the piece in the correct direction. I know that for sure. When it caught my hand was well over a foot away from the bit. You are correct about holding the piece though. I was holding the piece between my fingers and thumb. Obviously with quite a tight grip. I will take your advice next time and keep my fingers tucked under my hand. Thanks. I guess I will have to remake my template next time I go to build one of these, and make more careful cuts to ensure everything is quite close. My next purchase is a spiral up-cut bit too I guess. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
2006 Dodge Rims, Tires and Stereo Build (Pictures)
Top
Menu
Home
Refresh