Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
2 CompVR's
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="atraxtoxin" data-source="post: 378957" data-attributes="member: 552665"><p>Ya,</p><p></p><p>I needed some help wiring my subs to my amp...</p><p></p><p>I just bought 2 Kicker compvr's, 2 dual voice coil @ 2 ohms....rated to 400w RMS</p><p></p><p>and a RF 801X Amp 200x4 @ 2 ohm</p><p></p><p>I was wondering if it was possible to bridge the 4 channels into two channels and run my subs @ 400w but at 4ohms instead of 2ohms.</p><p></p><p>RF's website says you can do a 400x2 bridge mode @ 4 ohm.</p><p></p><p>This would put my subs in a series and increase the ohms to each speaker... so would that make the speaker actually run at 400w? or at 200w?</p><p></p><p>Thanks!</p></blockquote><p></p>
[QUOTE="atraxtoxin, post: 378957, member: 552665"] Ya, I needed some help wiring my subs to my amp... I just bought 2 Kicker compvr's, 2 dual voice coil @ 2 ohms....rated to 400w RMS and a RF 801X Amp 200x4 @ 2 ohm I was wondering if it was possible to bridge the 4 channels into two channels and run my subs @ 400w but at 4ohms instead of 2ohms. RF's website says you can do a 400x2 bridge mode @ 4 ohm. This would put my subs in a series and increase the ohms to each speaker... so would that make the speaker actually run at 400w? or at 200w? Thanks! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
2 CompVR's
Top
Menu
What's new
Forum list
